Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Kitchen Remodeling: The West Palm Beach Owner’s Guide
A full KraftMaid kitchen remodel in West Palm Beach typically runs $14,000 to $45,000 installed, and yes, we work with KraftMaid cabinetry every week. If you’re reading this because a hinge gave out, a drawer slide snapped, or a door face delaminated in the Florida humidity, the fix is usually far less than replacing the whole kitchen. We’ll match your existing KraftMaid line, order the right part, and install it without asking you to rip out cabinets that still have years of life in them.
Most homeowners discover a failed KraftMaid part the hard way: a drawer that won’t close square anymore, a soft-close mechanism that stopped catching, or a hinge screw that stripped out of the cabinet box. In West Palm Beach, the salt air and seasonal humidity swings accelerate the failures on older cabinets. The good news is that KraftMaid parts are spec’d and documented far better than most cabinet lines, which means the right replacement part almost always exists, and we can usually identify it from a photo and a measurement before we even schedule the visit.
Key takeaways:
- KraftMaid kitchen remodels in West Palm Beach run $14,000 to $45,000 installed, with cabinet installation alone at $4,000 to $13,000.
- We carry and order OEM KraftMaid hinges, slides, drawer boxes, and door faces, plus quality aftermarket equivalents where they make sense.
- Every job gets a written price before work starts, and every completed job is covered by the 365-Day Done Right Promise.
- Call (728) 203-9809 and a live person answers. No callbacks, no voicemail tag.
Which KraftMaid Models This Applies To
KraftMaid has built cabinets under a long list of product lines over the years: the standard KraftMaid line, KraftMaid Vantage, KraftMaid Passport Series, and the legacy KraftMaid Momentum and KraftMaid Genesis lines, among others. What matters more than the line name is the hinge type and the drawer slide spec. Older KraftMaid cabinets from the 1990s and early 2000s commonly used face-frame construction with a 3/8-inch reveal, while newer KraftMaid cabinets are almost universally frameless or full-overlay. The hinge cup diameter, the mounting plate hole pattern, and the slide length are the three measurements that determine what fits.
If you pull one drawer out and look at the slide, KraftMaid’s OEM slides are usually stamped with a manufacturer code on the side rail. Hinges are trickier because KraftMaid has sourced from several suppliers over the decades, including Blum and Grass, and the branding on a hinge does not automatically identify it as a drop-in match. This is where the OEM-vs-aftermarket decision gets real. For hinges and soft-close mechanisms, we usually recommend OEM or a Blum equivalent, because those parts take daily stress and a generic hinge shifts the door alignment by enough to notice. For drawer slides, a quality aftermarket slide from a brand like Blum or Hettich often installs cleaner than a 20-year-old OEM slide pulled from surplus stock.
The compatibility gotcha in West Palm Beach is this: humid coastal air swells cabinet boxes by two or three millimeters on older installations, enough that replacement drawer boxes cut to original factory dimensions sometimes bind. We field-measure every replacement box before ordering, because a drawer that fit in a Michigan showroom does not always fit in a West Palm Beach kitchen that has breathed salt air for a decade.
Styles & brands we work with
Signs Your KraftMaid Kitchen Remodeling Is Failing
- Drawer won’t close flush, or binds on one side. This is almost always a worn slide, a swollen drawer box, or a stripped screw hole in the cabinet side. In Florida humidity, the box swelling often masquerades as a slide problem, so we check the box before swapping hardware.
- Soft-close stopped catching, or slams shut. The damper mechanism inside the hinge or slide has worn out or been knocked out of alignment. Soft-close is a wear item, and Florida homes with hard water and humid air tend to shorten its lifespan by a few years.
- Hinge screws stripped from the cabinet face or door face. This is common on KraftMaid cabinets where the original screws were driven into particleboard. The fix is not simply a longer screw. We drill and fill with a proper substrate repair, then remount the hinge plate.
- Door face delaminating or warped at the edges. KraftMaid thermofoil doors hold up well, but after years of humidity cycling, the laminate can begin to separate at the bottom edge, especially above the dishwasher or sink. A replacement door face matched from KraftMaid’s current finish codes is usually the clean fix.
- Cabinet box separating at a corner or seam. This is a structural issue, not cosmetic. If a corner joint has opened up, the box is telling you the substrate has taken on moisture. We take this seriously because it affects the load path for the countertop above it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
If the issue is a single part or a handful of parts, you are looking at a repair call with parts and labor, not a remodel. In West Palm Beach, a typical KraftMaid hinge or slide replacement runs $150 to $400 installed depending on how many units are involved. A custom-matched replacement door face typically lands between $180 and $350 per door including finishing time. A full drawer box replacement with matching face runs $250 to $500 per drawer. If the failure is widespread enough that you are considering replacing a full run of cabinets rather than patching, a new KraftMaid cabinet installation in West Palm Beach runs $4,000 to $13,000 depending on linear footage and whether you are reusing the existing countertop.
Every one of those numbers is a written price before we touch the job. We do not quote a range and then move the number at the door. If we find additional damage behind the cabinet during the work, we call you before we touch it, we explain what we found, and we give you a written price for the additional scope. That is the Garrison Standard, and it applies to a $200 hinge swap the same way it applies to a $45,000 kitchen remodel.
The 365-Day Done Right Promise covers every part we install and every repair we make. If the part fails, the door sags, or the drawer binds inside the first year, we come back and correct it at no charge. That is in writing, signed, on every job.
DIY or Call Us?
For cabinet hardware, there is a safe middle ground, and I want to be straight about it because Curtis Lane has spent three decades watching homeowners turn a $30 hinge problem into a $700 cabinet-box problem. You can safely check the obvious: pull the drawer and look for a broken or bent slide, check whether a hinge screw has simply backed out, and confirm whether the soft-close mechanism is visibly cracked. If you find a stripped screw hole, a swollen drawer box, or a delaminating door face, stop. The fixes for those involve substrate repair, matched finishing, or remounting hardware under tension, and a botched repair degrades the cabinet box you are trying to save.
We carry common KraftMaid-compatible hinges, slides, soft-close mechanisms, mounting plates, and screws on the truck, which means a single service call often handles it. If it needs a custom-ordered part, we tell you that up front with a real lead time. Straight number, full scope, no surprises after the invoice. Call (728) 203-9809 and we will talk through what you are seeing.
FAQs
KraftMaid cabinets in West Palm Beach typically last 20 to 30 years with proper care, though hinges, slides, and soft-close mechanisms are wear items that usually need replacement every 10 to 15 years. The cabinet boxes themselves can last longer than the hardware if the substrate has not taken on moisture from humidity swings and coastal air. Call (728) 203-9809 for a free assessment of whether your cabinets are worth the repair.
A hinge with a stripped screw hole in the cabinet box can usually be repaired with a proper substrate fill rather than replaced, but a hinge with a failed internal spring or worn pivot should be replaced. We will tell you which one applies to your cabinet, and you will get a written price either way.
If we have the part on the truck, a hinge or slide replacement is typically a 30- to 60-minute job from arrival to cleanup. Custom-ordered door faces and drawer boxes take one to three weeks depending on KraftMaid’s current finish matching schedule. We give you a real lead time before we order anything.
We stock common KraftMaid-compatible hinges, slides, and mounting hardware on our trucks, and we order OEM KraftMaid door faces and drawer boxes directly for color-matched replacements. You do not need to source the part yourself, and we do not install customer-supplied parts without first confirming the spec. Call (728) 203-9809 and we will identify what you have.
Written by Curtis Lane, Owner, Bradford Remodeling Co – West Palm Beach at Bradford Remodeling Co West Palm Beach, serving West Palm Beach and nearby areas.
