Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boxabl Fence Installation: The West Palm Beach Owner’s Guide
Boxabl fence installation in West Palm Beach typically runs $3,500 – $9,000 installed, depending on linear footage, post depth, and whether we’re working with the standard Boxabl folding-panel perimeter system or a custom layout around a casita. Most owners call us after a storm or after the fence starts leaning at the hinge points, not because they planned the project months in advance. If your Boxabl fence is sagging at a fold, pulling away from the footing, or rattling in the wind off the Intracoastal, that’s a part failure with a clear fix, and we stock the replacement hardware on the truck for most West Palm Beach service calls.
Which Boxabl Models This Applies To
The Boxabl Casita ships with a lightweight perimeter fence system that uses hinged steel posts and aluminum infill panels, sized to match the 20-foot-by-20-foot module. The standard post-to-post spacing is 6 feet on center, and the factory fence stands 4 feet tall, which is below West Palm Beach’s 6-foot maximum for residential fence height, so no variance is needed for the stock setup. The compatibility gotcha we see most often in the field is the hinge pin size. Early production runs used a 1/2-inch pin, while later panels switched to a 5/8-inch pin. If your Boxabl was delivered before 2023, measure the pin before you order anything. Mismatched pins bind, strip, and turn a simple panel swap into a three-hour fight.
We’re an independent service provider, not affiliated with Boxabl, which means we match parts by measurement and serial number rather than by catalog guesswork. For the fence, OEM panels and aftermarket aluminum equivalents in the same gauge and finish are both available. We carry both on the truck so you never wait on a backorder for something as basic as a fence gate hinge.
We also stock parts for KraftMaid, Cambria, and Silestone, but the Boxabl fence system is a distinct animal, and we treat it that way.
Styles & brands we work with
Signs Your Boxabl Fence Installation Is Failing
- Panel sag at the hinge joint. The factory hinge pins are steel on aluminum, and in West Palm Beach’s salt air, galvanic corrosion eats the pin before the panel fails. You’ll see a rust line running down from the hinge and a panel that sits 1/2 inch lower than its neighbor.
- Leaning posts at the property line. Boxabl fence posts ship with a shallow 18-inch ground sleeve meant for compacted soil. West Palm Beach’s sandy loam doesn’t hold that sleeve the way the engineering specs assumed. We re-set posts at 30 inches with concrete collars, and that’s the difference between a fence that stands through hurricane season and one that’s flat by August.
- Gate that drags in the middle. The gate panel is the heaviest single piece in the system, and the hinges are not rated for the salt-mist exposure you get within three miles of the coast. Once the hinge bolts corrode, the gate drops, the latch no longer aligns, and you’re lifting it every time you walk through.
- Rattling infill panels in the wind. The panels slip into channels on the posts and rely on a single set screw per side. That screw works fine in a warehouse in Las Vegas. In West Palm Beach, afternoon squalls work those screws loose, and the panels chatter like a loose storm shutter.
- Powder coat blistering and peeling. The factory finish is a single-coat powder, and it fails fast against Florida UV and salt air. Once the aluminum is exposed, corrosion starts, and the panel is on borrowed time. We strip, re-prime, and re-coat rather than leaving bare metal to flake into your soil bed.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
A full Boxabl fence installation or panel-by-panel replacement in West Palm Beach runs $3,500 – $9,000, and the range is driven by three things: linear footage, post condition, and whether the concrete collars need re-pouring. A simple gate hinge and latch swap starts around $350 and is done in under two hours. Re-setting one leaning post with a 30-inch concrete collar runs $450 – $700. Replacing the full fence line around a Casita with new aluminum panels and re-set posts lands at the top of the range.
| Scope | Price Range |
|---|---|
| Gate hinge and latch replacement | $350 – $500 |
| Single post re-set with concrete collar | $450 – $700 |
| Full fence replacement (standard Casita perimeter) | $3,500 – $5,500 |
| Custom fence extension with gate and screening | $6,000 – $9,000 |
Every line item is on the written estimate before we start. No numbers move at the door. We pull the old hardware, dispose of it, install the new parts, and leave the site clean. The work carries the 365-Day Done Right Promise, which means if the fence fails inside a year, we come back and correct it at no charge. That’s in writing, per The Garrison Standard, and it covers labor and the parts we installed.
DIY or Call Us?
You can check the hinge pins yourself. Pull one, measure the diameter, and check for rust. If the posts are leaning, you can eyeball the gap between the post and the ground to see how far it has walked. That’s the extent of what we’d tell a homeowner to do. Setting a post in West Palm Beach means digging a 30-inch hole in sandy soil, setting a concrete collar, and getting the panel spacing right so the gate latch aligns. Get the depth wrong and the post leans again by June. Get the concrete mix wrong and you’re digging it out with a breaker bar in November. The fence is not high-tension, but it is a structural job in corrosive soil, and a fence that fails in a hurricane becomes a projectile. Call us at (728) 203-9809 and we’ll quote the fix straight, parts and labor, with the price in writing before anyone picks up a shovel.
FAQs
The factory fence lasts 3 to 5 years in West Palm Beach before hinge corrosion or post lean starts showing, and the finish typically fails around year 2 or 3. After our re-post and re-coat work, you can expect 10 to 15 years. Call (728) 203-9809 if you want us to inspect your fence and tell you exactly where it stands.
Yes, in most cases the post itself is fine and the failure is in the shallow sleeve or the concrete collar, which we re-set at 30 inches with new concrete and the post is reusable. We’ll only replace the post if the corrosion has eaten through the metal. Call (728) 203-9809 for a free estimate.
A full fence replacement around a standard Casita takes one to two days on site in West Palm Beach, including demolition of the old fence, post hole digging, concrete setting, and panel installation, with the gate aligned and test-swung before we leave. The concrete needs 24 hours to set before the panels go in, so most jobs wrap on day two.
We stock the common failure points on the truck: hinge pins, gate hinges, latches, set screws, and replacement aluminum panels in standard 4-foot Casita dimensions, plus the concrete and post sleeves we need for re-setting. If your panel is an unusual dimension or a custom extension, we order it and have it in hand within a week.
Written by Curtis Lane, Owner, Bradford Remodeling Co – West Palm Beach at Bradford Remodeling Co West Palm Beach, serving West Palm Beach and nearby areas.
