Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Driveway & Pavers: The West Palm Beach Owner’s Guide
Belgard driveway and paver work in West Palm Beach typically runs $7,000 to $18,000 installed, depending on square footage, substrate condition, and the specific Belgard line you choose. We stock Belgard-compatible pavers, edge restraints, bedding sand, and joint compound on our trucks, so most driveway repair or relay work can be quoted and scheduled within the same week. Most homeowners find us the hard way: a paver sinks after a heavy rain, an edge crumbles into the lawn, or the driveway develops a low spot that holds water for three days after every afternoon storm. That failure is almost never the paver itself. It’s what’s underneath it.
In West Palm Beach, we deal with a very specific set of conditions: sandy loam that shifts, a water table that sits close to the surface in older neighborhoods like Flamingo Park and Grandview Heights, and summer rains that test every joint. Belgard pavers are manufactured to a compressive strength that handles driveway loads, but no paver survives a failed base. When the base goes, the surface tells you first.
Which Belgard Models This Applies To
Belgard produces three primary driveway-suitable lines. The first is Catalina Grana, a smooth-faced paver available in 60mm and 80mm thicknesses. For a residential driveway in West Palm Beach, the 80mm is the correct specification if you’re parking a full-size pickup or an SUV; 60mm is better suited to walkways and patios. The second is Urbana Stone, which comes in a modular three-piece system that interlocks tightly, and the third is Holland Stone, a rectangular paver often specified for its classic look and availability.
Here’s a compatibility gotcha worth knowing: Belgard changed the mold dimensions on certain Urbana Stone pieces in 2019. If your driveway was installed before that, matching new pieces to old ones can be off by a sixteenth of an inch, which shows up as uneven joints. We keep our eyes on this when we do partial repairs, and we’ll tell you if a true match is no longer available. For OEM versus aftermarket: we install genuine Belgard pavers because the color consistency across a full pallet matters on a driveway. Generic replacements from a big-box store fade differently under Florida sun, and six months later the patch is visible from the street.
Bradford Remodeling Co West Palm Beach is an independent service provider. We are not affiliated with Belgard, but we work with their products daily and order direct from their Florida distribution centers.
Styles & brands we work with
Signs Your Belgard Driveway & Pavers Are Failing
- One or two pavers sit lower than the surrounding surface. This is base settlement, usually from uneven compaction or a washout after years of Florida downpours. The paver hasn’t failed. The support under it has.
- Weeds are growing through the joints in the same spots every month. Joint sand has washed out, which means water is getting under the pavers and carrying away the setting bed. If this isn’t addressed, the pavers start to shift and rock.
- The edge of the driveway is crumbling or the outside row of pavers is tilting outward. This is a failed edge restraint. In West Palm Beach, homeowners with St. Augustine grass along the driveway see this often, because lawn irrigation keeps the edge soil soft and the restraint lets go.
- Water pools on the driveway after a ten-minute rain and stays for more than a day. This means the surface has lost its slope. Either the base settled unevenly or the original install was pitched wrong. Belize City isn’t the concern here; it’s that standing water accelerates joint erosion and invites mosquito breeding.
- Pavers shift or wobble when you step on them. The bedding sand layer has thinned or washed away in spots. A wobbling paver is a cracked paver waiting to happen, and on a driveway, cracks spread quickly under vehicle weight.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For West Palm Beach, a full Belgard driveway installation falls between $7,000 and $18,000 depending on the condition of the existing base. A partial repair like replacing a sunken section, re-sloping a problem area, or rebuilding a failed edge runs lower, but we quote those after we see the site, not over the phone.
Here’s what drives the range:
- Square footage. A two-car driveway is roughly 400 to 600 square feet. Belgard pavers run $8 to $15 per square foot for material alone, with labor, base prep, and haul-away layered on top.
- Base condition. A failed base means excavation, new crushed concrete or limestone, and compaction. On older West Palm Beach properties where the original base was installed thin, redoing it correctly is the largest line item.
- Edge restraints and drainage. If the original edges failed, we replace them with aluminum or poly restraints pinned to spec. If the driveway pitches toward the house, we may recommend a channel drain to keep water moving.
Every quote from Bradford Remodeling Co West Palm Beach is a written price before any work begins. That price includes the pavers, base materials, labor, debris removal, and the 365-Day Done Right Promise. If the work fails inside a year, we return and correct it at no charge. That’s in writing, signed by Curtis Lane, every time.
DIY or Call Us?
You can safely do a few things before calling: clear weeds from the joints, note where water pools, and mark the sunken pavers with a piece of chalk so you can show us exactly what you’re seeing. You can also run a hose over the area to watch how water moves. That kind of information helps us quote accurately.
But paver replacement is not a weekend repair, and here’s the honest split. Replacing a single broken paver is manageable for a homeowner with basic tools. Replacing a section of driveway that has a failed base is a different job entirely. You’re lifting pavers, excavating to the right depth, compacting in lifts, re-screening bedding sand, re-setting surface, and re-sanding joints with polymeric sand that must cure correctly or it hardens into a mess on the paver face. Done wrong, you’ll have the same failure again by next rainy season. That’s why we keep our crew on these jobs. If you want to talk it through, call us at (728) 203-9809 and we’ll tell you what your specific situation needs.
FAQs
A correctly installed Belgard driveway with an 80mm paver, compacted base, and maintained joints lasts 25 to 30 years in the West Palm Beach climate. The failure point is almost always the base or the edge restraint, not the paver itself, which is why the install details matter more than the product choice.
Yes, when the base under the problem area is stable enough to work with, we quote a partial repair that addresses only the failed section. If the base throughout has shifted or the original install was thin everywhere, a partial fix becomes a band-aid, and we’ll tell you that directly. Call (728) 203-9809 for a site assessment and a written quote either way.
Most full driveway replacements in West Palm Beach take three to five working days, including excavation, base compaction, paver installation, and joint sanding. Weather in South Florida can stretch that, and we’ll tell you at the start which days we expect to be on site.
We stock common Belgard colors and sizes on our trucks for repairs, and we order pallets direct for full driveway installations. For the older models where exact color matches matter, we pull a sample from your driveway and match it against the current production run before we order a single piece. That keeps a patch from looking like a patch.
Straight number, full scope, no surprises after the invoice. If your Belgard driveway in West Palm Beach is failing, call (728) 203-9809 and we’ll put eyes on it, give you a written price, and tell you exactly what needs to happen and why.
Written by Curtis Lane, Owner, Bradford Remodeling Co – West Palm Beach at Bradford Remodeling Co West Palm Beach, serving West Palm Beach and nearby areas.
