Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cambria Driveway & Pavers: The West Palm Beach Owner’s Guide
We install and repair Cambria-brand pavers and driveway systems throughout West Palm Beach, with typical paver driveway installations running $7,000 to $18,000 depending on square footage and site prep. Most owners call us because they’ve noticed a paver has cracked, sunken, or shifted out of alignment, or because a section of the driveway has started holding water after a hard rain. You don’t need to rip out the whole driveway: in a lot of cases, we can pull and re-set the affected area, match the Cambria paver profile, and have it looking squared away without replacing the entire run.
Here’s the thing about pavers in South Florida that most people don’t learn until something fails. The paver itself rarely “breaks” in the way a garage door spring or a water heater fails. What fails underneath it is the substrate, the compacted base layer that holds the paver in place. When West Palm Beach’s sandy soil shifts or washes out after heavy summer rains, the base settles unevenly and the paver tilts or cracks. That’s the real repair, and it’s why a quick paver swap without fixing the base is just a temporary patch. Our crews pull the section, re-compact the base properly, and re-set the pavers so they stay put.
Key Takeaways:
- Paver driveway installation in West Palm Beach runs $7,000 – $18,000; small repairs and re-sets are handled at a labor-plus-materials rate with a written price first.
- Most “failed” pavers are actually a failed substrate underneath them, not a defective paver.
- We stock common Cambria paver profiles on our trucks, but odd lots and discontinued colors are special-ordered and matched by photo and measurement.
- Every repair and installation is covered by the 365-Day Done Right Promise in writing.
Which Cambria Models This Applies To
Cambria manufactures driveway and patio pavers in several profile families: smooth-finish slabs, tumbled-edge cobbles, and large-format planks. The names change with the product line, but the compatibility questions stay the same. The critical measurement on any driveway or paver job is thickness. Driveway-rated pavers are 60mm or 80mm thick, while patio and walkway pavers are usually 40mm to 50mm and are not built for vehicle weight. If a paver was installed on a driveway and it’s cracked down the middle, one of the first things we check is whether someone used a patio-weight paver to save money. In West Palm Beach, where we get heavy afternoon storms and occasional tropical weather, that shortcut fails fast.
To identify what you have, check the underside of a pulled paver for a molded manufacturer’s mark or size stamp. Cambria’s current driveway lines are modular, meaning a 60mm paver can interlock with others in the same series, but not with a different manufacturer’s profile, even if the top dimensions look close. We’re an independent service provider and not affiliated with Cambria, so our recommendation on OEM versus aftermarket is practical: if the project is an active driveway, stay with Cambria or a direct dimensional match so the lock-up stays tight. If it’s a small decorative repair on a patio, a quality equivalent from Belgard or Unilock, both of which we carry, can match color and profile close enough that the eye won’t catch it.
Styles & brands we work with
Signs Your Cambria Driveway & Pavers Is Failing
- Pavers have tilted or “lipped” at the edges. One paver sits higher than the one next to it. That’s almost always base settlement, not a bad paver. The base has compacted unevenly underneath it, and the paver is simply following the ground down.
- Standing water pools in one section after rain. West Palm Beach gets a lot of rain in a short window, and a correctly sloped driveway should shed it. If water collects and sits, the substrate underneath is washing out or the original grade was off. Over time, that pooled water is what causes the next paver to sink.
- A visible crack runs across multiple pavers in a straight line. That pattern usually points to vehicle weight exceeding what the paver thickness can carry, or a void in the base directly underneath. Single-paver corner chips are normal wear; a crack through three or four in a row is structural.
- Weeds or sand are pushing up between the joints. Some joint sand loss is normal, but aggressive weed growth and wide sand gaps mean the edges aren’t locked anymore. That allows the pavers to drift and eventually fail.
- Edging has popped loose or pulled away from the curb. The edge restraint is what keeps the whole field locked together. When it fails, the outer pavers start walking outward and the entire section loses tension.
Replacement Cost & What’s Included
For a full paver driveway installation in West Palm Beach, the installed price range is $7,000 to $18,000. The spread depends on driveway square footage, the thickness of the paver (60mm versus 80mm), how much of the existing base has to be excavated and re-compacted, and the Cambria paver series you choose. A driveway replacement, including tear-out of old pavers or poured concrete, fits in the $5,000 to $14,000 range depending on the condition under the old surface. Small repairs, like pulling and re-setting a 50-square-foot sunken section, are quoted as labor-plus-materials because the ground condition underneath is what drives the real work. We’ll never give you a number over the phone and then add to it at the door. You get a written line-item price before we start, and that’s the number on the invoice. Every job carries the 365-Day Done Right Promise in writing: if the work fails inside a full year, we come back and correct it at no charge.
Straight number, full scope, no surprises after the invoice.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can check a few things yourself before calling. Walk the driveway after a rain and mark where water pools. Look at the edging on all four sides and see if any section has pulled loose. Tap a few pavers with a rubber mallet: a hollow sound means a void underneath. What you shouldn’t do is start pulling pavers and re-setting them with bagged sand from the hardware store. Once the base is disturbed, it has to be re-compacted in lifts with the right equipment and the correct drainage slope re-established, or you’ll be looking at the same problem in six months. And doing it yourself on a vehicle driveway means you’re working with several tons of material. This isn’t a weekend job where the worst outcome is a crooked line. A failed repair means the new pavers crack under the car, and now you’re paying twice. Call (728) 203-9809 and we’ll inspect the site, tell you what’s failing, and give you a written price before any work starts.
FAQs
In our South Florida climate, a properly installed 60mm or 80mm Cambria driveway paver on a compacted base should last 25 to 30 years before the surface wears meaningfully, though the base may need attention sooner after major weather events or if drainage was never corrected. The paver itself won’t fail first unless it was underspecified; the base is the thing that ages. If you’re seeing sunken sections at year eight or ten, it’s a base problem, not a paver problem. Call (728) 203-9809 and we’ll tell you exactly what’s happening under there, free.
Yes, and that’s how we approach most jobs. A sunken or cracked section can usually be isolated, the pavers pulled, the base re-compacted, and the same pavers re-set if they’re intact. Full replacement is for cases where the failure covers most of the driveway, the edging has failed on multiple sides, or the wrong paver thickness was used originally. Call (728) 203-9809 for a straight answer on which one you’re dealing with.
Small section repairs are typically completed in one to two days, including base re-compaction and joint sand. A full driveway replacement, including tear-out, base prep, and paver installation, runs four to seven working days depending on size and weather. We pull permits when the scope requires it, and we schedule around West Palm Beach’s inspection timelines so you’re not waiting on a surprise delay. Call (728) 203-9809 for a written timeline with your quote.
We stock common Cambria paver profiles and colors on our trucks for repairs, and we special-order odd lots or discontinued colors through our supplier network. You don’t handle the procurement and you don’t pay a markup we can’t explain: the written quote shows the paver cost, the base material cost, and the labor as separate lines. We also carry Belgard and Unilock pavers, along with KraftMaid, Silestone, and Kohler for our remodeling work, so the same sourcing discipline applies across everything we install. Call (728) 203-9809 and we’ll match what you have before we schedule anything.
Get a Written Price for Your Cambria Driveway or Pavers in West Palm Beach
If your Cambria driveway or paver area is cracking, sinking, or holding water, call (728) 203-9809 and talk to a live person, any hour of any day. We’ll schedule a site visit, identify what’s actually failing, and give you a written line-item price before any work starts. The quote you get is the price you pay, the crew is background-checked and uniformed, and every job ends with a clean site and a signed written guarantee in your hand. I’m Curtis Lane, owner of Bradford Remodeling Co West Palm Beach. We’ve been doing this work long enough to know that the only thing harder than a bad paver base is a contractor who won’t put a number in writing. We don’t put you through that.
Written by Curtis Lane, Owner, Bradford Remodeling Co – West Palm Beach at Bradford Remodeling Co West Palm Beach, serving West Palm Beach and nearby areas.
