Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
See the difference
Before
After
Before
After
Before
AfterHow Much Does Metal Roof Installation Cost in West Palm Beach?
Metal roof installation in West Palm Beach typically costs between $15,000 and $40,000 for a standard single-family home. Most homeowners in neighborhoods like El Cid, Flamingo Park, and Pineapple Park pay around $22,000 to $28,000 for a complete standing seam or stone-coated steel system on a 1,800 to 2,400 square foot roof. The range swings based on panel profile, metal gauge, roof complexity, and whether the old roof needs a full tear-off.
At Bradford Remodeling Co West Palm Beach, we put that number in writing before a single tool comes out. No surprise line items at the door. No “we found rot” phone calls after the tear-off. Our written price covers the scope we agreed on, and our 365-Day Done Right Promise means if anything fails inside the first year, we come back and correct it at no charge. Curtis Lane runs our West Palm Beach operation, and every metal roof project goes out under The Garrison Standard, the framework we’ve operated under since 2004 as part of the Garrison Partners family.
Key Takeaways
- Typical range: $15,000 – $40,000 for a full metal roof installation in West Palm Beach.
- Per square foot: $8 – $16 installed, depending on panel type and gauge.
- Most common spend: $22,000 – $28,000 for a standard single-family home.
- Biggest price drivers: panel profile, metal gauge, roof pitch, tear-off requirements, and underlayment choice.
- Payback: Metal roofs routinely outlast asphalt shingles by 2 – 3x, which matters when your homeowners insurance carrier is asking about wind mitigation in a hurricane zone.
Metal Roof Installation Cost Breakdown (2026)
Here’s what the numbers actually look like for a West Palm Beach metal roof project. These ranges assume a typical single-story or two-story home with a roof deck in reasonable condition. If your plywood decking is rotted from years of humidity and the occasional hurricane-driven rain, expect the tear-off line item to move up.
| Line Item | Typical Cost Range | Notes |
|---|---|---|
| Tear-off and disposal (old roof) | $2,500 – $5,500 | Asphalt shingle removal, haul-away, dump fees. Steep roofs and limited access add labor. |
| Decking repair / replacement | $800 – $3,200 | Replacing rotted plywood or adding a thermal barrier. Common in older West Palm Beach homes near the intracoastal. |
| Underlayment (synthetic, high-temp) | $1,200 – $2,800 | Florida code requires a secondary water barrier. We spec a high-temp synthetic underlayment rated for metal panels. |
| Standing seam metal panels (24 – 26 gauge) | $8,000 – $18,000 | Material only. 24 gauge costs more and stands up better in high wind. Steel, not aluminum. |
| Stone-coated steel panels | $9,500 – $20,000 | Material only. Heavier profile, better hail resistance, popular in communities with strict aesthetics rules. |
| Flashing, trim, ridge caps, closures | $1,500 – $4,000 | Valleys, chimneys, skylights, pipe boots. This is where cheap crews cut corners. We don’t. |
| Labor (installation) | $5,000 – $12,000 | Includes panel layout, fastening, detailing. Two to five days for a standard roof. |
| Fasteners and sealants | $300 – $800 | Stainless or coated fasteners rated for coastal exposure. Not the box-store zinc stuff. |
| Permits and inspections | $400 – $900 | City of West Palm Beach building permit, plus re-inspection fees if the inspector finds an issue. |
Total estimate: $15,000 – $40,000. If a proposal comes in under $10,000 for a full metal roof in West Palm Beach, read the fine print. That price usually means exposed-fastener panels, 29-gauge metal, no synthetic underlayment, and a crew that won’t answer the phone when a panel lifts in the first tropical storm.
What Moves the Price Up or Down
- Roof pitch: Anything over 7/12 adds staging labor and safety time. Flat or low-slope roofs often need specialized panel profiles and more detailing.
- Roof complexity: Hip roofs with multiple valleys, dormers, or a chimney cost more than a simple gable. Every penetration is a leak risk if flashed wrong, and correct flashing takes time.
- Panel gauge: 24-gauge steel typically runs $1 – $2 more per square foot than 26-gauge, but it holds its shape better in a 140 mph wind event. Given West Palm Beach’s wind zone, we spec 24-gauge on most of our jobs.
- Home size: The $15,000 – $40,000 range assumes roughly 1,500 – 3,000 square feet of roof area. A 4,000+ square foot estate home in Ibis or Mirasol can push well past $50,000.
- HOA requirements: Some communities, especially gated developments around Palm Beach Lakes and the Preserve, mandate specific metal profiles or colors. Custom colors from certain manufacturers add $1,500 – $4,000.
What Affects Metal Roof Installation Pricing in West Palm Beach
West Palm Beach is not Orlando or Jacksonville. Our pricing reflects the realities of building in a coastal hurricane zone, and the factors below are specific to this market.
- Wind code compliance: Palm Beach County sits in the High Velocity Hurricane Zone, which requires Miami-Dade or Florida Building Code-compliant panel systems. Those systems use more fasteners, stronger clips, and a heavier gauge. Compliance costs money, and skipping it will get your installation flagged on a wind mitigation inspection. This matters for insurance premiums.
- Salt air corrosion: Homes within a few miles of the Intracoastal Waterway need coated fasteners and either aluminum or a high-grade Galvalume steel finish. Galvanized fasteners will rust out in five years near the water. Rust bleeding down a white standing seam roof is a real thing we’ve been called to fix, and it’s never a cheap fix.
- Decking condition: A 1950s ranch in Southland Park or a 1970s build in Bear Lakes often has plywood decking that has absorbed decades of humidity. By the time the old shingles come off, we find soft spots that have to be cut out and replaced. We include a decking repair allowance in every written price so the number doesn’t change when we lift the old roof.
- Radiant barrier and insulation decisions: Metal roofs in South Florida get hot. A radiant barrier under the panels, usually a foil-faced underlayment, can cut attic temperatures by 30 degrees. It adds $1,000 – $2,500 to the job and pays back in air conditioning load during August. Homes off of Southern Boulevard with older HVAC systems see the most benefit.
- Permit turnaround: West Palm Beach’s building department has had backlogs, and that affects scheduling. We pull permits early and schedule roofs around inspection windows. If a homeowner wants to fast-track, it doesn’t change the price, but it does change the start date.
- Crew availability and season: Peak roofing season runs from November through April. You’ll get the same written price from us in July as you will in January, but a mid-summer roof on a 2001 home off Village Boulevard is hot work and the crew paces the job accordingly. That doesn’t change the cost. It changes the timeline.
How to Save on Metal Roof Installation
One way to save: don’t buy a roof twice. The cheapest exposed-fastener panel roof in West Palm Beach can look fine in year one and start leaking around the screw gaskets by year eight. The rubber washers degrade in UV and heat, and every one of those thousands of screws is a future leak point. A standing seam system has concealed fasteners, no exposed washers, and a service life that runs 40 to 60 years in Florida with proper detailing.
Practical ways to keep the number at the low end of the $15,000 – $40,000 range:
- Hold off on the tear-off if it isn’t needed. If your existing roof is a single layer of shingles and the decking is solid, you can sometimes install a metal roof over it with a properly rated underlayment. That saves $2,500 – $5,500. We’ll tell you straight if your roof qualifies. Most West Palm Beach homes don’t have more than one layer, which helps.
- Choose 26-gauge over 24-gauge if your roof is under a tree canopy. The wind load reduction from surrounding homes and mature oaks in neighborhoods like Flamingo Park can make 26-gauge a legitimate choice. We’ll still spec it with proper clips and fastening patterns.
- Keep the profile simple. A straight gable roof with a single ridge costs less than a hip roof with four valleys and two dormers. More seams, more flashing, more labor.
- Pay attention to underlayment, not just panels. The panel is the visible part. The underlayment is what keeps water out if a panel gets dented by flying debris. A high-quality synthetic underlayment is roughly $1,200 – $2,800 and is not the line item to cut.
- Get a written number before you commit. Bradford gives you a written price before work starts, every time. That means you can compare bids on actual line items, not a vague “we’ll see how it goes.” Call (728) 203-9809 for a free estimate. Curtis or one of our project leads will walk the roof, explain what we see, and put the number in writing.
Metal Roof vs. Shingle Roof: What the Numbers Actually Say
A standard architectural shingle roof in West Palm Beach runs $8,000 – $20,000. A metal roof runs $15,000 – $40,000. That gap gives a lot of homeowners pause. Here’s the math that matters.
A shingle roof in Florida lasts 12 – 18 years before the sun and humidity bake it brittle. Some fail faster. A metal roof, properly installed, lasts 40 – 60 years. Over a 50-year horizon, you’ll buy three or four shingle roofs versus one metal roof. The shingle roofs add up to $30,000 – $70,000 in today’s dollars. The metal roof is a single $15,000 – $40,000 spend.
There’s also the insurance angle. A metal roof with a Miami-Dade notice of acceptance and the right wind mitigation credits can reduce your windstorm premium in Palm Beach County by a meaningful amount. That’s a conversation between you and your carrier, but we can provide the product approvals and installation documentation they’ll ask for.
If you’re weighing both options, our Metal Roof Installation in West Palm Beach page covers the materials, panels, and process in detail. We also do full home remodeling, so if the roof is one piece of a larger plan, we can coordinate the whole scope under one written price.
FAQs – Metal Roof Installation Cost
How much does a metal roof cost per square foot in West Palm Beach?
Expect $8 – $16 per square foot installed. Standing seam with 24-gauge steel lands around $12 – $16 per square foot. Exposed-fastener 26-gauge panels come in around $8 – $10 per square foot. The lower number is not the better deal in a hurricane zone. Call (728) 203-9809 and we’ll give you a written per-square-foot figure for your actual roof, not a range off the internet.
Is a metal roof worth the extra cost in South Florida?
For most homes in West Palm Beach, yes. A $15,000 – $40,000 metal roof replaces three to four shingle roofs over the same period that would total $30,000 – $70,000. Add the wind resistance, the insurance wind mitigation documentation, and the lower radiant heat in the attic, and the long-term case is strong. The main reason to choose shingles is a near-term budget constraint.
How long does a metal roof installation take in West Palm Beach?
Most residential metal roofs take 3 to 7 working days from tear-off to final inspection. A simple gable roof over a 1,500 square foot home can be done in three days. A complex hip roof with dormers, a chimney, and multiple skylights can run 7 to 10 days. Permitting and inspection scheduling in Palm Beach County can add a week or two to the front end, which is why we pull permits before we tear anything off.
Do metal roofs rust in Florida’s salt air?
Steel panels with a proper Galvalume coating and a quality paint system hold up within a few miles of the coast. The failure point is almost always fasteners. Galvanized fasteners will corrode and bleed rust streaks onto the panels within five years of salt exposure. We spec stainless or appropriately coated fasteners for every coastal job. For homes right on the water, aluminum panels are worth considering, though they run on the higher end of the $15,000 – $40,000 range due to material costs.
Is it cheaper to repair an existing metal roof or replace it?
If you already have a metal roof that’s within 10 – 12 years old, isolated repairs usually make sense. A panel replacement with flashing and fasteners runs $600 – $2,500 depending on access and panel profile. But if the roof is 25+ years old, the fasteners are failing across the entire field, or a roof-over was done without an underlayment, you’re better off with a full replacement. We’ll tell you which one it is, and the estimate for either is free.
What to Expect When You Call Bradford Remodeling Co West Palm Beach
A live person answers, any hour. That’s not a line. Our phones are staffed 24/7, and you won’t sit through a voicemail tree. Tell us the address and what you’re seeing; we’ll schedule a roof walk with Curtis Lane or one of our senior project leads.
During the walk, we check the roof, the soffits, the fascia, the decking condition, and the existing ventilation. You’ll get a written price that breaks out materials, labor, permits, and the underlayment. If the decking needs work, that’s in the written price too, not discovered later as a change order.
Every metal roof we install goes out with the 365-Day Done Right Promise. If the work fails inside the first year, for any reason related to the installation, we return and correct it at no charge. The promise is in writing, and it’s signed at close-out along with the final scope document. That’s The Garrison Standard. It’s how we’ve operated since 2004, and it’s why homeowners in West Palm Beach who’ve been burned by no-shows and surprise invoices call us first.
Free estimates. Written price before any work starts. Call (728) 203-9809 to schedule yours.
Pricing reflects the West Palm Beach market as of 2026. Bradford Remodeling Co West Palm Beach offers free estimates – call (728) 203-9809.
What Our Customers Say
"Home remodel with a new floor plan. Handled structural work and permits without drama."
- Gus R."Kitchen remodel run by a veteran-owned crew. They started on the day promised, kept the site clean, and gave weekly updates. New cabinets and counters look great."
- Alan M."Solid job. Small punch list items were done within a few days of the walkthrough."
- Beth K.
